Setting All Font Values at Once

You can set the font style, weight, variant, size, line height, and family all at once.

To set all font values at once:

1.	Type `font:`.
2.	If desired, type `normal`, `oblique`, or `italic` to set the font style (see page 154). Figure 10.21. This style sheet is equivalent to the one shown in Figure 10.19 on page 158. I've simply consolidated the `font` properties for the `h1`, `h2` and `p` rules. Note that I don't have to specify that the `font-weight` be `normal` for `h1`, `h2`, since `normal` is the default for the `font` property.
3.	If desired, type `normal`, `bold`, `bolder`, `lighter`, or a multiple of `100` (up to 900) to set the font weight (see page 154).
4.	If desired, type `normal` or `small-caps` to remove or set small caps (see page 167).
5.	Type the desired font size (see pages 156 157).
6.	If desired, type `/line-height`, where line-height is the amount of space there should be between lines (see page 156).
7.	Type a space followed by the desired font family or families, in order of preference, separated by commas, as described on page 152.

Tips

You can also set each property separately. See the page referenced with the desired step.
The first three properties may be specified in any order or omitted. If you omit them, they are set to normalwhich may not be what you expected.
The size and family properties must always be explicitly specified: first the size, then the family.
The line height, which is optional, must come directly after the size and the slash.
The font property is inherited.