Conditionally executes a set of commands based on the value of a logical expression.
IF lExpression [THEN] Commands [ELSE Commands] ENDIF
Specifies the logical expression that is evaluated. If lExpression evaluates to true (.T.), any commands following IF or THEN and preceding ELSE or ENDIF (whichever occurs first) are executed.
If lExpression is false (.F.) and ELSE is included, any commands after ELSE and before ENDIFare executed.
If lExpression is false (.F.) and ELSE isn't included, all commands between IF and ENDIF are ignored. In this case, program execution continues with the first command following ENDIF.
- If lExpression is false (.F.) and ELSE is included, any commands after ELSE and before ENDIFare executed.
You can nest an IFВ ...В ENDIF block within another IFВ ...В ENDIF block.
Comments preceded by && can be placed on the same line after IF, THEN, ELSE, and ENDIF. These comments are ignored during compilation and program execution.
CLOSE DATABASES OPEN DATABASE (HOME(2) + 'Data\testdata') USE Customer && Open customer table GETEXPR 'Enter condition to locate ' TO gcTemp; TYPE 'L' DEFAULT 'COMPANY = ""' LOCATE FOR &gcTemp && Enter LOCATE expression IF FOUND( ) && Was it found? DISPLAY && If so, display the record ELSE && If not found ? 'Condition ' + gcTemp + ' was not found ' && Display a message ENDIF USE